ADDjust A Sec. Specs

The ADDjust A Sec. adds a delay between when the Shutter-Beam detects the subject and when your camera or strobe is fired. This delay is continuously adjustable from 100 uS (0.0001 seconds) up to 2 seconds. This delay allows the subject to move a little before the picture is taken.

SPECIFICATIONS:

Delay Ranges (seconds):

 

Range

Decimal

Fraction

Words
(uS=Microseconds)
(mS=Milliseconds)
Range 1 0.0001 to 0.001 1/10,000 to 1/1,000 100 uS to 1 mS
Range 2 0.001 to 0.01 1/1,000 to 1/100 1 mS to 10 mS
Range 3 0.01 to 0.1 1/100 to 1/10 10 mS to 100 mS
Range 4 0.1 to 1 second 1/10 to 1 seconds 100 mS to 1 Seconds
Range 5 0.2 to 2 seconds 1/5 to 2 seconds 200 mS to 2 Seconds


Infinitely adjustable within each range.

Input Type: 1.0K Ohm pull up to 9 Vdc
Trigger Source: Contact Closure (<5 Ohms)
Input Closure Duration: 0.0001 sec min
Camera Output Duration: .5 Seconds
Power Source: 9 Vdc Battery
Input Connector: 2.5mm Jack (+ center)
Camera Out Connector: 2.5mm Jack (+ center)
Strobe Out Connector: PC Jack
Camera Output: NPN Transistor 50v @ 1 amp
Strobe Output: SCR 600v, 8 amp

Specification Subject to change without notice.

Questions about the ADDjust A Sec specifications? Email me.


Return to Equipment ..... Return to home page